Brass Cylinder Hinges are used on 3/4" wood for flush inset applications such as inset doors and drop leaf tables. These brass barrel hinges are produced with heavy gauge brass plated steel linkage, hinge opens to 180 degrees.
Easy to install, simply drill hole the exact diameter of the cylinder hinge, insert the hinge and adjust the wedge-tightening screw. These hinges are not intended for load bearing applications. Once installed hinges provide an invisible appearance.
Marked center line, in each direction, with a square to locate center
Drill holes using exact diameter of hinge and exact depth of hinge (do not use oversize drill bits) Use 10 mm metric bit for 10 mm diameter, 12 mm metric bit for 12 mm diameter and 14 mm metric bit for 14 mm diameter.
Insert hinge-barrel into each hole. Simultaneously press hinge-barrel into each section. Gradually open and close, making small corrections as needed to ensure hinge is straight and not twisted. Should be flush with surface once in place.
Tightening the set screw expands the special built in wedge action providing a secure application.