Victorian Drawer Pulls

Victorian Drawer Pull

• 3" Center Hole to Center Hole
• Overall Width: 4-3/4" 
• Overall Height: 2-5/8" 
• Eyebolt Shank Length: 1"

This drawer pull is very representative of the Victorian era with its stamped brass backplate featuring a medallion like center and rococo scrollwork. The brass handle is held by 2 brass-plated eyebolts. The finish is shiny. It is not lacquered and will age over time.

This handle can also be used on some serpentine drawer fronts as the backplate can be gently bent. 

Install Victorian Drawer Pulls

• Handle attaches to drawer with two eye bolts.
• To Install: start from drawer front.
• Insert eyebolts through holes in rosettes, front to back. Eyebolt shank length is 1", if too short counter sink eyebolt-nut in wood. 
• Continue inserting post through holes in drawer, allowing posts to be loosely positioned.
• Position handle and insert handle-ends into 2 eyebolts.
• Push eyebolts with handle into place.
• From drawer interior, screw nuts on bolts and tighten.