Pivot Mirror Hinges

These Pivot Hinges are for a dresser or vanity mirror with a wooden frame. Mounts to backside of mirror and upright supports. Width of hinge can be adjusted. As hinges work under pressure, mirror is easily tilted forward or backward, remaining in place. Adjust friction by tightening screws on upright supports. 

Pivot Mirror Hinges

• Height: 1-1/4"
• Width: Adjustable 1-1/2" - 2"
• Screw holes  ¾” center to center, top to bottom.
  

These pivot hinges are heavy gauge steel. They have a brass-plated finish.

Install Friction Hinge

• Before mounting: if necessary to adjust location of hinge on pin, use a flat head screw driver to pry open side of keeper, that does not have rivet., slide pin as needed. Be careful so that screw driver does-not slip and hurt you.
  
• Hinges surface mount to backside of mirror
• Determine mounting location. Spacing between frame and upright must be at least 1/4"
• Drill pilot holes for screws at correct placement
• Attach one hinge to each side of mirror frame back. 
• Place mirror between upright supports and attach.
• Adjust friction by tightening the screws.