Iron Wall Lamp with Mercury Reflector, White Font, Oil

Iron Wall Lamp with Mercury Reflector easily mount to wall at desired position. Mercury reflector attaches to swing arm of bracket lamp reflecting light produced by lamp. This refection coupled with light of the lamp is plentiful. 

Iron Wall Lamp

• Type: Oil burning
• Use with lamp oil, Not-Included
• Install oil lamp guide below
• Takes a 7/8" width wick
• Projection from wall: 13-1/2"

This lamp is built with a sturdy, matte black cast-iron bracket. It features a historic mercury-like glass reflector.  It has a clear glass chimney with crimp top and white glass font. The brass-plated oil burner with white cotton wick. *These bracket lamps are historic copies. Due to manufacturing processes, the glass may have slight imperfections as do the old ones.*

Guide for Oil Burning Lamps

• Only use "lamp oil" as a fuel source. Other oil types can cause fires and/or damage oil burners.
• Leave at least a ½ inch of head-space when filling up your oil lamp.
• Keep lamp reservoir half full so that wick stays properly saturated
• Oil lamps burn approximately ½ ounce of lamp oil per hour.
• Trim off charred edge of wick after every couple uses. If charred residue is not kept trimmed, wick will likely smoke and provide dim light.
• Replace lamp chimney once lamp is lit to protect flame from drafts.
• Caution: A burning oil lamp should not be left unattended. Lamps should be placed out of the reach of children.

Install Antique Bracket Lamp

• Determine best location to hang lamp
• Lamp must be mounted near an electric outlet, for cord to plug into
• Lamp hangs from matching support-bracket called a wall plate (see below)
• Wall plate is attached by 2 screws
• When installing be sure to screw bracket to a wall-stud
• Once attached to wall, slide post on end of lamp-arm into support-bracket.
• Screw electric-lamp-burner with shade holder attached, if using, into glass lamp font.
• Place font in bowl-shaped area of lamp bracket
• Add light bulb
• Position chimney on burner so that tines hold chimney in place
• Add lamp shade
• Plug into wall