Victorian Replacement Handles for Drawers

Rosette Bail Pulls

Victorian Replacement Handles are used on standard drawers and some that are serpentine-curved. Absence of a solid back-plate allows handle to swing freely over curved areas without binding. These authentic replacement handles were often seen on furniture from the Victorian or Golden Oak eras.

Victorian Replacement Handles for Drawers 3" Center Hole to Center Hole Overall Width: 3-7/8" Overall Height: 1-7/8" Rosette Diameter: 7/8" Eyebolt Shank Length: 1" matching antique finish handle

When replacing existing handles always check boring-measurement

These rosette bail pulls are brass. Each handle includes bail, 2 circular rosettes and 2 eyebolts with nuts. Bail hangs from two eye bolts.  

Measure Victorian Dresser Pulls

• Boring is the space between center of mounting hole to center of adjacent mounting hole. If changing handles, on existing drawers, this measurement is  crucial.
• There is considerable more flexibility if installing handles on new furniture or cabinets. Mounting holes can be drilled where needed for new installations.
• Overall Size reflects: width and height of handle at widest point. Ideally a balanced relationship between drawer handle and drawer is best.

Install Victorian Drawer Pulls

• Handle attaches to drawer with two eye bolts.
• To Install: start from drawer front.
• Insert eyebolts through holes in rosettes, front to back. Eyebolt shank length is 1", if too short counter sink eyebolt-nut in wood. 
• Continue inserting post through holes in drawer, allowing posts to be loosely positioned.
• Position handle and insert handle-ends into 2 eyebolts.
• Push eyebolts with handle into place.
• From drawer interior, screw nuts on bolts and tighten.