Oil Burning Wall Lamp with Mercury Reflector

Vintage Bracket Lamp with Reflector

Oil Burning Wall Lamp with Mercury Reflector produces a soft reflected yet bright light. Authentically reproduced to burn lamp oil. Maximize light output is achieved by a combination of reflected and actual light. Mount lamp to wall in location where light is needed. Shift arm to best position. Adjust reflector slightly to best direct light. 

This lamp is built with a sturdy, matte black cast-iron bracket. It features a historic mercury-like glass reflector.  It has a clear glass chimney and font. The brass-plated oil burner with white cotton wick. *These bracket lamps are historic copies. Due to manufacturing processes, the glass may have slight imperfections as do the old ones.*

Oil Lamp Guide

• Only use "lamp oil" as a fuel source. Other oil types can cause fires and/or damage oil burners. Burns approximately 0.5 ounces of lamp-oil per hour.
• Leave at least a ½ inch of head-space when filling up your oil lamp.
• Keep lamp reservoir half full so that wick stays properly saturated
• Oil lamps burn approximately ½ ounce of lamp oil per hour.
• Trim off charred edge of wick after every couple uses. If charred residue is not kept trimmed, wick will likely smoke and provide dim light.
• Replace lamp chimney once lamp is lit to protect flame from drafts.
• Oil lamps are only for indoor use.
• Caution: A burning oil lamp should not be left unattended. Lamps should be placed out of the reach of children.

Install Bracket Oil Lamp

Determine placement of wall lamp

• Oil lamp should-not be positioned near any combustible source
• Heat must have space to escape lamp chimney
• Lamp hangs from matching rectangular support-bracket
• Support-bracket is attached by 2 screws
• When installing be sure to screw wall plate to a wall-stud
• Once attached to wall, slide post on end of lamp-arm into support-bracket.
• Insert black-post, on back of reflector, through hole in bracket.
• Screw reflector-nut onto black post to secure reflector in place. 
• Pour lamp oil into font
• Screw oil-lamp-burner into glass lamp font.
• Place font in bowl-shaped area of lamp bracket
• Position chimney on burner so that tines hold chimney in place