Embossed Victorian Drawer Pulls, Antique

Antique Victorian Drawer Pulls are nicely shaped to fit many mid size drawers. Bold stamped design give added dimension to this authentic antique drawer pull. Useful on serpentine drawer fronts as this reproduction pull can be gingerly shaped to conform to curve. This was often seen on some oak furniture.

Antique Brass Victorian Drawer Pulls 3" Center Hole to Center Hole Overall Width: 4-1/8" Overall Height: 2-3/8" Eyebolt Shank Length: 1" Corresponding Keyhole Cover matching Polished Brass Pulls

Always check boring-measurement when replacing handles on drawers

Handle backplate is stamped brass with a scroll design. The dimple pattern brass bail is held with two brass-plated eyebolts. The finish is darkened to look old.

As the backplate is stamped brass, these pulls can be gently curved to fit some drawer fronts.

Measuring Victorian Drawer Pulls

• Boring: distance between center of mounting hole to center of adjacent mounting hole.
• If replacing handles:  replacement-handle-boring must match actual boring measurement in drawer.
• Overall Size: width and height of handle at widest point.

Install Victorian Drawer Pulls

• Handle attaches to drawer with two eye bolts.
• To Install: start from drawer front.
• Insert eyebolts through holes in backplate, front to back. Eyebolt shank length is 1", if too short counter sink eyebolt-nut in wood. 
• Continue inserting eye-bolts through holes in drawer, allowing eye-bolts to be loosely positioned.
• Position handle and insert handle-ends into 2 eyebolts.
• Push eyebolts with handle into place.
• From drawer interior, screw nuts on bolts and tighten.