Antique Cabinet Drawer Lock, backset 1-1/8 inch

Many historical locks are no longer made due to limited demand.
If a specific lock is not shown in our lock collection then we do-not know of a source.

Half Mortise Lock

• Backset-Distance To Pin: 1-1/8" (29 mm) this measurement is critical if replacing a lock as keyhole in lock and furniture must line up together.
• Lock Plate: 2-3/4" Wide x 1-7/8" High (70 mm x 48 mm)
• Selvedge: 2-3/4" x 9/16"
• Lock Body Thickness: less than 9/16"
• Bolt Projection: 1/4"
  
  Helpful information on selecting and replacing half mortise locks.
  

Keyed alike

• Key Size: Barrel: 3/16" x 1-3/4", 2-1/4" Overall Length, Key-bit Height: 7/16"
• Keyhole-covers not-included as furniture style dictates design
• also Inserts: #0242,#0237, #0253 fit this lock

Install Considerations

If replacing a lock, we suggest reading: What you need to know about selecting and replacing half mortise locks.

1. Strikes were rarely used with half mortise locks. Typically wood is notched to accept bolt. However if preferred a generic #4521 strike is available separately.
2. When using on doors: select according to side door is hinged on. This lock is for cabinet doors hinged on right.
3. When using on drawers: Keyholes are off-center requiring lock to be positioned accordingly.
4. Lock installs into a partial cut out in furniture. In closed position, lock is not seen. 

If replacing a lock: the backset measurement must be determined

• If you have original lock: measure distance between top edge of lock to lock pin in center of keyhole. This measurement is known as the backset.
• If old lock not available, determine backset by measuring: distance from center of keyhole (where lock pin will be) to top edge of drawer or side edge of door.
• The backset measurement of the replacement lock, must match backset measurement in original lock and/or keyhole location measurement in drawer or cabinet door.