Floral Table Lampshades, 14 inch

Harp Lamp Shade

Ships Free to contiguous 48 US states

Size

• Fitter type: Harp
• Typically used on lamp bases 10" or taller
  
• 14" Bottom, Point to Point
• 9-1/2" Top, Point to Point
• 9" Side

Floral Table Lampshades are American made. They are both unique and very decorative. Sprays of dahlias, poppies and roses clamber to be seen. This cheerful option will brighten any room. Use on table lamps with a lamp harp.

These floral table lampshades are made of parchment. They are produced on a sturdy, rust resistant metal frame. The frame has a small ring, at top of shade, to sit on harp post. Exterior of frame is covered with parchment paper. The paper is stabilized and strengthened with hard white buckram (a coarse linen lining) for added strength.  To complete the appearance a gold taped binding is added to accent top bottom and individual sections. These harp lampshades are a vintage style. Made in USA

More Floral Lampshades

• 12" Chimney Lampshade
• 14" Chimney Lampshade
• Uno Bridge Lamp Shade
• 10" Clip on Lamp Shade

Measure Harp Lamp Shades

Standardized Lamp Shades Measurements

• Top: diameter across top of shade
• Bottom:  diameter across base of shade
• Side: straight measurement of the slant-side of shade

A small 1/2" ring fitter is at center top of a harp lamp shade frame. This ring sits on post at top of harp and is secured by a lamp finial. 

Guidelines for determining which Harp Lamp Shade to select

These generalizations apply to many lamps however personal taste should be the guiding influence. 

• Height of Lamp Shade: approximately 2/3 rds height of lamp-base. (height of lamp base: distance from bottom of lamp base to base of lamp socket)
• Bottom-diameter of Lamp Shade: approximately 1”-2” less than lamp-base height. Bottom diameter should not exceed lamp-base height. 
• 
  
• Lamp shade proportions should reflect lamp base proportions. For example: a short squat lamp will look best with a shade of similar proportions.
• Using the same lamp shade base shape, round or square, provides a cohesive appearance.
• If using incandescent light bulbs there should be a minimum of 3-1/2” between lamp shade and bulb to allow heat escape.
• If the preferred lampshade size is not available, it is normally best to choose a slightly larger rather than smaller size shade.
• Change harp height if the lampshade is sitting too high or low on the lamp.