Victorian Dresser Handles

Brass Drawer Pulls

Enhance the wood's inherent charm with Victorian Dresser Handles, featuring a stunning open work backplate. Ideal for Victorian and Golden Oak furniture from the mid-1800's to the 1920's, with a 3" boring size that fits most pieces from this era.

Victorian Dresser Handles 3" Center Hole to Center Hole Overall Width: 3-7/8" Overall Height: 2-3/16" Eyebolt Shank Length: 1" matching antique brass handle

If replacing drawer handles, check distance between holes

This openwork handle has a cast brass backplate, brass bail and 2 brass-plated eyebolts.  The polished finish is not lacquered and will age overtime. 

This drawer pull does is not suitable for use on serpentine-shaped drawers as backplate does not bend.

Measure Victorian Drawer Handles

• Boring: distance between center of mounting hole to center of adjacent mounting hole.
• If replacing handles:  replacement-handle-boring must match actual boring measurement in drawer.
• Overall Size: width and height of handle at widest point.

Install Victorian Drawer Pulls

• Handle attaches to drawer with two eye bolts.
• To Install: start from drawer front.
• Insert eyebolts through holes in backplate, front to back. Eyebolt shank length is 1", if too short counter sink eyebolt-nut in wood. 
• Continue inserting post through holes in drawer, allowing posts to be loosely positioned.
• Position handle and insert handle-ends into 2 eyebolts.
• Push eyebolts with handle into place.
• From drawer interior, screw nuts on bolts and tighten.