Antique Finish Brass Mirror Screws

Brass Mirror Screws

• Ring Diameter: 1-1/8" 
• Stem Projects: 2" Length, 3/16" Diameter
• Additional 2 longer stems included providing a 3" projection if needed.
• Spacer: 5/8" diameter, 1/4" thick
• Insert Bushing: 3/8" body diameter, 9/16" head diameter, 5/8" overall length

These mirror screws have solid brass circular ends.  Spacers and insert bushings are also brass. Stems are all thread steel. Brass has an antique finish to look old.

Install Cheval Mirror Screws

• Determine mirror screw placement. Typically 3"-4" above center height of cheval mirror.
• Drill 3/8" hole in each side-end of mirror frame.  Depth of hole must be deep enough to allow stem to protrude past insert. Screw insert busing into hole.
• Drill 9/32" hole, through each side-standard,  at hanging location.  Allow clearance space between bottom of mirror and standard base. 
• Insert steel stem through standard, through spacer and into insert-bushing. Stem can be cut to shorter length if needed.
• Screw stem into insert in mirror. Loosely tighten to hold mirror in place.
• Adjust mirror to preferred position and carefully tighten so as not to crack mirror.