Antique Cabinet Drawer Lock, backset 1-1/8 inch

This cabinet drawer lock features a traditional design that was often used on antique and vintage drawers, desks, and cabinet doors that are hinged on right. The secure lever locking mechanism ensures reliable functionality. Once installed, this lock is not visible from the exterior of furniture. 

This is a half mortise style lock. The lock fits into a partial cut out in furniture interior. No strike is necessary. Key turns one lever mechanism to secure lid. 

Half Mortise Lock

Helpful information on selecting and replacing half mortise locks.

• Backset-Distance To Pin: 1-1/8" (29 mm) If replacing an old lock, BACKSET SIZE is critical, as keyhole in lock and furniture must line up together.
• Overall: 2-3/4" Wide x 1-7/8" High (70 mm x 48 mm)
• Selvedge: 2-3/4" x 9/16"
• Bolt Projection: 1/4"
• Key Size: Barrel: 3/16" x 1-3/4", 2-1/4" Overall Length, Key-bit Height: 7/16"

Finding an exact match for an old lock is not always possible, as only a limited amount of sizes are now  made.

• Keyhole-covers not-included as furniture style dictates design
• also Inserts: #0242,#0237, #0253 fit this lock

This lock is well-made with attention to detail. It has a sturdy extruded brass face plate, steel box, and brass bolt.  It has a secure lever locking mechanism. Made in England.

Install Considerations

If replacing a lock, we suggest reading: What you need to know about selecting and replacing half mortise locks.

1. Strikes were rarely used with half mortise locks. Typically wood is notched to accept bolt. However if preferred a generic #4521 strike is available separately.
2. When using on doors: select according to side door is hinged on. This lock is for cabinet doors hinged on right.
3. When using on drawers: Keyholes are off-center requiring lock to be positioned accordingly.
4. Lock installs into a partial cut out in furniture. In closed position, lock is not seen. 

If replacing a lock: the backset measurement must be determined

• If you have original lock: measure distance between top edge of lock to lock pin in center of keyhole. This measurement is known as the backset.
• If old lock not available, determine backset by measuring: distance from center of keyhole (where lock pin will be) to top edge of drawer or side edge of door.
• The backset measurement of the replacement lock, must match backset measurement in original lock and/or keyhole location measurement in drawer or cabinet door.